How to install and configure SIPTAPI
Posted by on 22 October 2013 06:22 PM
SIPTAPI is a SIP based call-control client which can be used to initiate phone calls.
SIPTAPI is not a full SIP client, thus a dedicated
SIP client – a SIP softphone or hardphone – is needed
SIPTAPI will instruct the SIP client to call a certain number
How to get it
Copy siptapi.tsp into the windows\system32 directory
Go to your Control Panel click on Phone And Modem Options, choose Advanced, Click Add, Choose SIP TAPI Service Provider
Then highlight SIP TAPI Service Provider and Choose Configure…
Configure your username, password and SIP domain.
Sip domain will be: sip.sipresource.com
User will be your 3NG Account ID
Password will be your 3NG Account Service password
Authentication-User will be your 3NG Account ID
Click on a contact from the People view then click more and Call.
Once the New Call dialog pops up, click on Dialing options and make sure you have the Connect using line – set to SIPTAPI.
Click OK then you can start the call.
**Issues with MS Comunnicator or Lync 2013:
When either of these are installed, outlook will default to them for making calls. In order to fix this please use the following steps.
-If you want to use Outlook 2007/2010 with TAPI you have
to make sure to not use Office Communicator, otherwise Outlook
tries to initiate the call via Office Communicator instead of TAPI.
In short, to use Outlook 2007/2010 with TAPI you have to (untested):
If you are using 64bit version of Windows/Outlook try the following key instead (or create both keys):
For more details please refer to: